STIHL KM 110 R Manuál s instrukcemi stáhnout pdf (Strana 18)

KM 110 R

English

16

N Turn the choke knob to e.

N Set the slide control, lockout lever

and throttle trigger to the starting

throttle position.

N Start the engine by pulling the

starter rope briskly – 10 to 20 pulls

may be necessary.

If the engine still does not start

N Move the slide control to STOP-0.

N Remove the spark plug – see

"Spark Plug".

N Dry the spark plug.

N Crank the engine several times with

the starter to clear the combustion

chamber.

N Refit the spark plug – see "Spark

Plug".

N Move the slide control to START.

N Set the choke knob to e – even if

the engine is cold.

N Now start the engine.

Throttle cable adjustment

N Check adjustment of throttle cable –

see chapter on "Adjusting the

Throttle Cable".

Fuel tank run until completely dry

N After refueling, press the fuel pump

bulb at least five times – even if the

bulb is filled with fuel.

N Set the choke knob according to

engine temperature.

N Start the engine.

During break-in period

A factory-new machine should not be

run at high revs (full throttle off load) for

the first three tank fillings. This avoids

unnecessary high loads during the

break-in period. As all moving parts

have to bed in during the break-in

period, the frictional resistances in the

engine are greater during this period.

The engine develops its maximum

power after about 5 to 15 tank fillings.

During Operation

After a long period of full throttle

operation, allow the engine to run for a

short while at idle speed so that engine

heat can be dissipated by the flow of

cooling air. This protects engine-

mounted components (ignition,

carburetor) from thermal overload.

After Finishing Work

Storing for a short period: Wait for the

engine to cool down. Empty the fuel tank

and keep the machine in a dry place,

well away from sources of ignition, until

you need it again. For longer out-of-

service periods – see "Storing the

Machine".

If there is a noticeable loss of engine

power

N Turn the choke knob to g

N Take out the screw (1) and remove

the filter cover (2).

N Clean away loose dirt from around

the filter.

N Grip the filter element (3) at the

cutout (arrow) in the filter

housing (4) and remove it.

N Fit a new filter element. As a

temporary measure you can knock it

out on the palm of your hand or blow

it out with compressed air. Do not

wash.

N Replace damaged parts.

Installing the filter

N Install the filter element in the filter

housing and fit the cover.

N Insert the screw and tighten it down

firmly.

Operating Instructions Cleaning the Air Filter

1

273BA006 KN

2

4

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 75 76

Komentáře k této Příručce

Žádné komentáře