STIHL KM 110 R Manuál s instrukcemi stáhnout pdf (Strana 23)

KM 110 R

English

21

N Refit the pawl (5) in the rotor.

N Fit the washer (4) on the starter

post.

N Use a screwdriver or suitable pliers

to fit the spring clip (3) on the starter

post and over the pawl's peg – the

spring clip must point

counterclockwise – as shown in the

illustration.

N Go to "Tensioning the Rewind

Spring".

Replacing a broken rewind spring

N Remove the rope rotor as described

in chapter on "Replacing the starter

rope".

WARNING

The bits of spring may still be under

tension and could fly apart when you

take them out of the housing. To reduce

the risk of injury, wear face protection

and work gloves.

N Remove the spring housing and

pieces of spring.

N Lubricate the new spring with a few

drops of non-resinous oil.

N Position the new spring housing,

bottom plate facing up, against the

cutouts (arrows).

N Push the spring housing into the

starter cover.

N Reinstall the rope rotor – then go to

"Tensioning the Rewind Spring".

N If the spring pops out of the spring

housing and uncoils: Refit it

counterclockwise, starting outside

and working inwards.

Tensioning the rewind spring

N Make a loop in the unwound starter

rope and use it to turn the rope rotor

six full revolutions in the direction of

the arrow.

N Hold the rotor steady. Pull out and

straighten the twisted rope.

N Let go of the rotor.

4

3

5

249BA013 KN

249BA018 KN

249BA016 KN

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 75 76

Komentáře k této Příručce

Žádné komentáře